KK V5.5 4 Mode Program 4 Axis Flight Control Board Flight Controller Version 2.9

V2.3 KK Flight Control Circuit Blackboard KK V5.5 Flight Control Board Multi-Copter 4 Axis Atmega168 For Quadcopter Hexa Copter Drone Aircraft

This KKMulticopter controller is a flight control board for up to 6 Rotor Aircraft. Its purpose is to stabilize the aircraft during flight. To do this it takes the signal from the three onboard gyros (roll, pitch, and yaw) and then passes the signal to the Atmega168PA IC. The Atmega168PA IC unit then processes these signals according to the user’s installed software and passes control signals to the installed Electronic Speed Controllers (ESCs). These signals instruct the ESCs to make fine adjustments to the motors rotational speed which in turn stabilizes your Quadcopter.

These control boards also use signals from your radio systems receiver (Rx) and pass these signals to the Atmega8PA IC via the ail (aileron), ele (elevator), (throttle), and rud (rudder) inputs. Once this information has been processed the IC will send varying signals to the ESCs which in turn adjust the rotational speed of each motor to induce controlled flight (up, down, backward, forwards, left, right, yaw).

This is the latest v.5.5 KKmulticontroller that has been factory-made and fully populated. It uses the Murata piezoelectric gyros which have been incorporated into the board design for robustness. The Yaw gyro assembly is also slot mounted for extra robustness. These gyros have proven to be the most vibration resistant of all the gyros we have tested so far.

The board comes in black with a blue LED and has an onboard In System Programming (ISP) header to enable easy firmware updates with a recommended programmer. The on board Atmega168PA chip gives users the extra space to load expanded firmware with higher refresh rates to enhance stability.

The three adjustable potentiometers increase or decrease gyro gain for all three axes (Roll, Pitch, and Yaw) and can be used to calibrate the ESCs and reverse the gyro directions if necessary during pre-flight setup.

The board also has six ESC/Servo headers which allow multicopter configurations from 2 to 6 rotors. There are also headers for the aileron, elevator, throttle, and rudder connections from your RC Receiver(RX). The board comes with 4 x 3-pin jumper cables to connect your RX to the board quickly and easily.

Features:

100% Brand new

Latest KK multi-copter controller V5.5 Board, V2.1 program

Simple structure, Easy to Maintain and Debug Control with 3 pcs gyros, relying on potentiometer adjust gyro sensitivity.

Full servo signal output, support normal ESC / analog servo

Support for single-axis / UFO, Y3 3-axis, Y3-type 3-axis, 4 axis, 6 axis, V22 flight mode

Supports 4-axis “+” and “X” flight modes, support for six-axis “HEXA6” and “Y6” flight modes.

Don’t need MK 4-axis PPM decoder board, the receiver can be connected directly to the Transmitter.

Specification:

IC: Atmega168PA

Gyro: ENC-03RC x 3

Input Voltage: 3.3-5.5V

The signal from Receiver: 1520us (4 channels)

Signal to ESC: 1520us (4 ESCs)

Dimensions: 50mm x 49mm x 14.5mm

Mounting hole: 45 x 45mm x 3mm dia

Weight: 14.5 grams

Notice: that this is not used for parameter adjustment, it’s only for flashing different firmware of the KK Flight control Circuit board! when you purchase this item, please contact me for getting a driver, flashing tools, and different flying firmware!

Package Content:

1 x V2.3 KK Flight Control Circuit Blackboard KK V5.5 Flight Control Board