Type:Common Anode
Emitting Color:Red
Size: 19mm x 12.7mm x 8mm ( L x W x H )
Forward Voltage:DC1.8V
Forward Current:15-20mA
Subtotal: රු1,510.00
In stock
Type:Common Anode
Emitting Color:Red
Size: 19mm x 12.7mm x 8mm ( L x W x H )
Forward Voltage:DC1.8V
Forward Current:15-20mA
රු55.00
In stock
CompareType:Common Anode
Emitting Color:Red
Size: 19mm x 12.7mm x 8mm ( L x W x H )
Forward Voltage:DC1.8V
Forward Current:15-20mA
Only logged in customers who have purchased this product may leave a review.
84 X 84 dot matrix LCD, can show 4 lines of characters
Use serial interface communicate with the master processor, the number of interface signal line reduced greatly, only 8 signal lines including power and GND. Support different types of MCU, such as the SPI,MCS51 serial mode 0 of AVR. Transfer rate up to 4Mbps,can full speed write display data without waiting time.
Here we have a very popular LCD Keypad shield for the Arduino.
It includes a 2×16 LCD display and 6 momentary push buttons. Pins 4, 5, 6, 7, 8, 9 and 10 are used to interface with the LCD. Analog Pin 0 is used to read the pushbuttons.
The LCD shield supports contrast adjustment and backlit on/off functions. It also expands analog pins for easy analog sensor reading and display. Below the shield can be seen attached to an Arduino UNO.
OLED display, without backlight, self-illumination, display performance is better than traditional LCD display, but also reduces consumption.
Driver IC: SSD1306
Size: 0.91 inch OLED
Resolution: 128 x 32
IIC interface
Display: 0.28″LED, red/yellow/blue/green (optional)
Size: 30*11.7*9.2mm (L*W*H)
Material: PP+electronic components
2 wire working voltage:4.0~40V (with reverse connection protection)
2 wire detection voltage:0.0~40V
3 wire working voltage:4.0~40V (with reverse connection protection)
There are no reviews yet.