Feature:0.96" OLED Display 2.4GHz Dual-Mode WiFi + Bluetooth Development BoardDevelopment board based on ESP-WROOM-32Supporting the LwIP protocolSupporting three modes: AP, STA, and AP+STADescription:..

Warnings:1.This module requires a 3.3 volt supply for VCC, and 3.3V logic.2.It is not 5V tolant,Connect RX or TX on 5V    For Arduino    will destroy this module.3.You must use a l..

Description :DIYmall for Wemos D1 V1.0.0-ESP32 Wifi Wireless Bluetooth Module CP2104 ESP-WROOM-32Descriptions:wireless onlineBluetooth4MB flashLithium battery interface, 500mA maximum charging current..

ESP32 is already integrated antenna and RF balun, power amplifier, low-noise amplifiers, filters, and power management module. The entire solution takes up the least amount of printed circuit boa..

Features:*Low-power dual-core 32-bit CPU for application processors.*Main frequency up to 240MHz, computing power up to 600 DMIPS.*Built-in 520 KB SRAM, external 4M PSRAM.*Support interfaces such as U..

Introduction:ESP32 is already integrated antenna and RF balun, power amplifier, low-noise amplifiers, filters, and power management module. The entire solution takes up the least amount of printe..

Introduction:ESP32 is already integrated antenna and RF balun, power amplifier, low-noise amplifiers, filters, and power management module. The entire solution takes up the least amount of printe..

Product DescriptionHardware Specifications  Chipset ESPRESSIF-ESP32 240MHz Xtensa® single-/dual-core 32-bit LX6 microprocessorFLASH QSPI flash 4MB / PSRAM  8MBSRAM 520 kB SRAMButton ResetUS..